Notes ยท 2026-10-20

Linear phase or minimum phase EQ: which to use

Both types can draw the same curve on the screen. They differ in what they do to timing, and that decides which one to use for a given job.

Minimum phase

This is how analogue filters behave. Boost or cut a band and the signal also shifts in phase around that band, in a fixed relationship to the amount of gain. It adds no delay and uses little CPU. Its impulse response starts immediately and rings after the main hit, which the ear is used to and tends to hide.

Linear phase

A linear-phase filter delays all frequencies equally, so the phase relationship between them is preserved. The cost is latency and a symmetrical impulse response, so the ringing also happens before the transient (pre-ringing). Narrow, steep boosts and cuts make that audible on drums and other sharp sounds. It also needs more CPU.

When to choose which

SituationPick
Everyday tracking and mixing, individual soundsMinimum phase
Anything where low latency matters (live, monitoring)Minimum phase
Processing several mics or paths of the same source that must keep their relative phase (drum overheads, parallel chains)Linear phase
Mastering with gentle, wide movesEither, linear phase is common
Steep high-pass or low-pass on bass-heavy materialBe careful: both have side effects, listen

Which one I reach for

Minimum phase is the right default for most work. Use linear phase when related signals must keep their phase relationship. Accept the latency, and keep boosts wide and moderate so pre-ringing stays below hearing.

If you are unsure, A/B at matched loudness and go with what you hear.

Related