Grains De-Esser

A de-esser that finds the sibilant band and turns it down, in two modes.

30 seconds to a good setting

Start from the preset Female Vocal (Vocals).

Click the preset name in the header to open the list. Init gives you the factory values.

  1. Put the plugin on the vocal and choose Female Vocal or Male Vocal.
  2. Turn on Listen. You now hear only the detected highs. Drag the two beads on the screen (or the From and To knobs) until the band covers the harsh "s" sounds.
  3. Turn Listen off. Drag the dashed Thresh line down until the reduction works only on the "s" and "sh" sounds. Lower is more.
  4. Set Range, the largest reduction allowed. Keep it as small as you can get away with.
  5. Choose a Mode: Split Band cuts only the sibilant highs, Wide Band dips the whole voice when sibilance hits.
  6. Choose a Detection: Absolute compares the level of the highs with the threshold, Relative compares them with the whole signal and works at any loudness.

Main controls

From and To
The lower and upper edge of the band where sibilance is detected. At its maximum, To is open upwards.
Thresh
De-essing starts above this level. Lower means more.
Range
The maximum gain reduction.
Release and Lookahead
How fast the reduction lets go, and how early it catches the start of an "s". Lookahead adds latency.
Listen
Plays only the detected highs, so you can set the band by ear.

If it sounds wrong

If the voice sounds like it has a lisp or went dull, raise Thresh, reduce Range, make the band narrower, or use Split Band. Use Bypass often: a de-esser is easy to overdo.

Other presets to try

  • Male Vocal (Vocals)
  • Harsh Sibilance (Vocals)
  • Gentle Air (Vocals)
  • Cymbal Tamer (Drums)

The same for every plugin: presets and A/B, Match and Delta, licence and trial, troubleshooting.