Grains Multiband Compressor
A four-band compressor with draggable crossovers, solo and bypass for every band.
30 seconds to a good setting
Start from the preset Gentle Master Glue (Mastering).
Click the preset name in the header to open the list. Init gives you the factory values.
- Put the plugin on the track or the master and choose Gentle Master Glue. For a boomy mix try Tame The Lows.
- Click a band on the screen, or use the Band switch (1 to 4) on the plate, to choose the band you edit.
- Drag the crossovers (the circles) sideways to decide where one band ends and the next begins.
- Drag the threshold of the band (the diamond) down until it just starts to work on the loud parts.
- Set Ratio, Attack and Release for that band. Use the Solo key to hear the band alone and Bypass to hear without it.
- Use the band Gain to set its level after compression. Use Mix for parallel compression and Output for the final level.
Main controls
- Band 1 to 4
- Which band the plate edits. Every band has its own threshold, ratio, attack, release and gain.
- Crossovers
- The three split points between the four bands.
- Solo and Bypass
- Hear one band alone, or hear the signal without that band compressed.
- Phase
- Dynamic leaves the signal untouched until a band acts. Crossover is the classic split into four bands and sum.
- Mix and Output
- Dry/wet balance for parallel compression, and the level after processing.
If it sounds wrong
If it sounds hollow, find the band that causes it with Solo and Bypass, then raise its threshold or lower its ratio. The Phase menu is worth a try in both positions.
Other presets to try
- Tame The Lows (Mix)
- Vocal Control (Vocals)
- Drum Bus Punch (Drums)
- Harshness Taming (Mix)
The same for every plugin: presets and A/B, Match and Delta, licence and trial, troubleshooting.
