Grains Tape Machine

A tape machine: saturation, head bump, high-frequency loss and wow and flutter.

30 seconds to a good setting

Start from the preset Subtle Glue (Mix).

Click the preset name in the header to open the list. Init gives you the factory values.

  1. Put the plugin on the track or the bus and choose Subtle Glue. For a darker, older sound try Warm Bus or Lo-Fi Cassette.
  2. Choose the tape speed: 15 ips is clean and wide, 7.5 ips is darker with a lower head bump, 30 ips reaches highest with a smaller, higher bump.
  3. Turn Input up: the harder the signal hits the tape, the more saturation you get.
  4. Set Head Bump for the low end of the replay head, and HF Loss for how far the highs roll off.
  5. Add Wow, Flutter and Drift for pitch movement. Leave them at 0 if you want the tape sound without it moving.
  6. Switch Auto Gain on and Alt-click Bypass to compare at equal loudness. Set Mix for the amount of tape.

Main controls

Speed
15, 7.5 or 30 ips. It sets the character and the frequency of the head bump.
Input and Asymmetry
How hard the signal hits the tape, and lopsided saturation for even harmonics.
Head Bump and HF Loss
Low-end resonance of the replay head, and how far the highs roll off.
Wow, Flutter, Drift
Slow pitch wander, fast pitch shimmer, and slow random wander. Wobble Rate and Stereo Spread shape them.
Hiss
Steady tape noise. 0 is off.
Mix, Output, Oversampling
Tape against the dry signal, the level after, and the quality of the processing (4x is a good default).

If it sounds wrong

If the sound is too dark, turn HF Loss down. If it seems seasick, turn Wow, Flutter and Drift down to 0. If it sounds too crunchy, lower Input.

Other presets to try

  • Warm Bus (Mix)
  • Master Polish (Mastering)
  • 70s Drums (Drums)
  • Vocal Warmth (Vocals)
  • Bass Weight (Bass)
  • Lo-Fi Cassette (Creative)

The same for every plugin: presets and A/B, Match and Delta, licence and trial, troubleshooting.