Grains Delay
A stereo delay with ping-pong, feedback filters, ducking and a freeze switch.
30 seconds to a good setting
Start from the preset Slapback (Vocals).
Click the preset name in the header to open the list. Init gives you the factory values.
- Put the plugin on the track, or on a send, and choose Slapback for a short echo or Vocal Throw for a longer one.
- Choose a Mode: Stereo (left and right independent), Ping-Pong (bounces side to side) or Mono.
- Set the time. Switch Sync on to lock the times to the tempo of the host, or turn the Time L and Time R knobs. Tap sets Time L when you click it on the beat.
- Set Feedback for the number of repeats.
- Use Low Cut and High Cut so each repeat gets thinner and darker and sits behind the dry sound.
- Turn Ducking up so the echoes dip while the voice sings and come back in the gaps. Then set Mix.
Main controls
- Time L and Time R
- The left and right delay times. Link L/R makes the right side follow the left.
- Feedback
- How many repeats. Above 100% the echoes grow, and saturation keeps them in check.
- Low Cut and High Cut
- Filters inside the feedback loop, so each repeat is filtered again.
- Drive, Diffusion, Mod Rate and Mod Depth
- Saturate the repeats, smear them into a wash, and add pitch wobble.
- Ducking
- The echoes dip while the input plays.
- Mix and Output
- Dry/wet balance (the dry sound stays at full level up to 50%), and the level after the mix.
If it sounds wrong
If the echoes make the track muddy or busy, lower Feedback, raise Low Cut, lower High Cut, and turn up Ducking. Freeze loops the current echoes and ignores new input, so switch it off if the sound seems stuck.
Other presets to try
- Vocal Throw (Vocals)
- Ping-Pong 1/8 (Mix)
- Dotted Eighths (Guitar)
- Tape Echo (Mix)
- Ambient Wash (Creative)
The same for every plugin: presets and A/B, Match and Delta, licence and trial, troubleshooting.
