Grains Modulator

Chorus, flanger, phaser, vibrato and through-zero flanging in one plugin.

30 seconds to a good setting

Start from the preset Wide Chorus (Chorus).

Click the preset name in the header to open the list. Init gives you the factory values.

  1. Put the plugin on the track and choose Wide Chorus, Classic Phaser or Jet Flanger.
  2. Choose a Mode: Chorus, Flanger, Phaser, Vibrato or Through-Zero.
  3. Set Rate, the speed of the movement. Switch Sync on to lock it to the tempo of the host.
  4. Set Depth, how far the modulation sweeps. You can drag DEPTH on the screen too.
  5. For Flanger and Phaser add Feedback for a stronger, more resonant effect (a negative value inverts it).
  6. Set Mix. Around 50% is the classic flanger and phaser sound. Use Mono Check to hear the result summed to mono.

Main controls

Mode
Chorus, Flanger, Phaser, Vibrato or Through-Zero tape flanging.
Rate and Depth
Speed of the movement and how far it sweeps.
Feedback, Delay, Center
Resonance of the effect, the base delay time, and the middle frequency of the phaser sweep.
Voices and Stages
The number of chorus voices, and the number of phaser stages. More stages means more notches.
Spread and Drift
Left/right offset for width, and a slow random wander like an unsteady analog circuit.

If it sounds wrong

If it makes you seasick, lower Depth and Rate, or lower Mix. If the effect gets thin when you listen in mono, use Mono Check, lower Spread, and make Mix smaller.

Other presets to try

  • 80s Ensemble (Chorus)
  • Jet Flanger (Flanger)
  • Classic Phaser (Phaser)
  • Tape Wobble (Vibrato)
  • Deep Phaser 12-Stage (Phaser)

The same for every plugin: presets and A/B, Match and Delta, licence and trial, troubleshooting.