Grains Transient Shaper
A transient shaper: more or less punch, and shorter or longer tails, at any level.
30 seconds to a good setting
Start from the preset Punchier Kick (Drums).
Click the preset name in the header to open the list. Init gives you the factory values.
- Put the plugin on the track and choose Punchier Kick, Snare Crack or Fat Sustain.
- Turn Attack to the right for more punch on every hit, or to the left for less. It works at any level of the signal.
- Turn Sustain to the right for longer, fatter tails, or to the left for tighter, drier ones.
- Set Speed, how long the attack phase lasts. Short is only the click, long is the whole hit.
- Set Length, how much of the tail the Sustain knob shapes (the shaded window on the screen).
- Switch Soft Clip on if boosted peaks get too loud. Set Mix and Output.
Main controls
- Attack
- More punch (right) or less punch (left) on every hit.
- Sustain
- Longer, fatter tails (right) or tighter, drier ones (left).
- Speed and Length
- How long the attack phase lasts, and how much of the tail Sustain works on.
- Soft Clip
- Rounds off boosted peaks so they never clip the output.
- Mix and Output
- Dry/wet balance, and the level after processing.
If it sounds wrong
If the sound gets clicky or harsh, turn Attack down, make Speed longer, or switch Soft Clip on. If the room noise comes up too much, turn Sustain down.
Other presets to try
- Snare Crack (Drums)
- Tighter Room (Drums)
- Fat Sustain (Drums)
- Soften Picking (Guitar)
- Bass Definition (Bass)
The same for every plugin: presets and A/B, Match and Delta, licence and trial, troubleshooting.
