Grains Reverb

A reverb with five styles, a three-band decay and a ducking switch.

30 seconds to a good setting

Start from the preset Vocal Plate (Vocals).

Click the preset name in the header to open the list. Init gives you the factory values.

  1. Put the plugin on a send (or on the track) and choose Vocal Plate for a voice or Drum Room for drums.
  2. Choose a Style: Room (small), Hall (big), Plate (dense), Chamber (warm) or Ambient (huge and moving).
  3. Set Decay, the time the tail needs to fall by 60 dB, and Size for how big the space sounds.
  4. Set Predelay so the dry sound stays clear before the reverb starts.
  5. Use Low Cut and High Cut to thin out and darken the reverb. These only change the wet sound.
  6. Set Mix. On a send, put Mix at 100%. Turn Ducking up if the reverb covers the voice.

Level Match makes the dry/wet crossfade equal-power, so dry and wet do not stack. Freeze holds the current tail forever.

Main controls

Decay
Time for the tail to fall by 60 dB. You can drag M on the screen too.
Size and Predelay
How big the space sounds, and the gap before the reverb starts.
Low Decay and High Decay
Decay of the lows and highs compared with the mids. Drag L and H on the screen.
Early, Diffusion, Modulation
The level of early reflections, how dense or grainy the tail is, and movement that removes metallic ringing.
Low Cut and High Cut
Filters on the reverb (wet) only.
Ducking, Width, Mix, Output
The reverb dips while the input plays, its stereo width, the dry/wet balance and the level.

If it sounds wrong

If the reverb washes out the mix, shorten Decay, add Predelay, lower High Cut and turn Ducking up. If it rings like metal, raise Modulation or Diffusion.

Other presets to try

  • Small Room (Mix)
  • Drum Room (Drums)
  • Snare Plate (Drums)
  • Concert Hall (Mix)
  • Ducked Vocal Hall (Vocals)

The same for every plugin: presets and A/B, Match and Delta, licence and trial, troubleshooting.