Grains Filter

A filter with seven types that moves by LFO, by tempo or by how loud the input is.

30 seconds to a good setting

Start from the preset Slow Sweep (Movement).

Click the preset name in the header to open the list. Init gives you the factory values.

  1. Put the plugin on the track and choose Slow Sweep for a movement, DJ High-Pass for a simple filter, or Auto-Wah for a filter that follows the playing.
  2. Choose a Type: LP 24, LP 12, HP 24, HP 12, Band, Notch or Comb.
  3. Drag the bead on the screen: sideways sets the cutoff, up and down sets the resonance.
  4. Set Rate and Depth for the movement of the LFO. Switch Sync on to lock the Rate to the host tempo. Choose the LFO Shape.
  5. Turn Env Amt up (or down, negative) to let a louder input open (or close) the filter.
  6. Set Mix and Output.

Main controls

Cutoff and Reso
The filter frequency, and the boost at the cutoff. LP 24 and HP 24 self-oscillate near 100%.
Drive
Pushes the filter into analog-style saturation.
Rate, Depth, LFO Shape
Speed, range in octaves and waveform of the sweep. A negative Depth inverts it.
Env Amt, Attack, Release
How strongly and how fast the input level moves the filter.
Spread
Offsets the right LFO for a wide, swirling movement.

If it sounds wrong

If the sound is too harsh or starts to whistle, lower Reso and Drive. If it is too dark, raise the Cutoff, or check that Depth and Env Amt are not closing the filter.

Other presets to try

  • Auto-Wah (Movement)
  • Tempo Wobble (Movement)
  • Lo-Fi Radio (Tone)
  • DJ High-Pass (Tone)
  • Resonant Squelch (Synth)

The same for every plugin: presets and A/B, Match and Delta, licence and trial, troubleshooting.