Grains Limiter

A limiter with true-peak protection and a loudness meter, made to sit last in the chain.

30 seconds to a good setting

Start from the preset Streaming Safe (Mastering).

Click the preset name in the header to open the list. Init gives you the factory values.

  1. Put the plugin last on the master (or on the track you want to limit) and choose Streaming Safe.
  2. Check the Ceiling. The preset sets -1 dBTP, a safe value for streaming. You can drag the dashed Ceiling line on the screen.
  3. Raise Gain while the music plays. Louder means more gain reduction, shown from the top of the graph.
  4. Choose a Style: Transparent (clean, adaptive release), Punchy (keeps transients), Loud (soft clipper into the limiter) or Safe (gentle and slow, for buses).
  5. Leave True Peak at 4x for the final master. Switch Dither to 16-bit only for the very last bounce to a 16-bit file.
  6. Read the loudness display (integrated, momentary, short-term and range). Click it to start measuring again. The number above the output meter is the highest true peak of the output in dBTP; click the meter to reset it.

Main controls

Gain
Drives the signal into the limiter. This is how you make it louder.
Ceiling
The output never goes above this level.
Release
How fast the gain reduction recovers. Shorter is louder but can distort. All the way down is Auto release.
Lookahead
Longer is smoother, shorter is punchier. It adds latency.
True Peak
Oversampling for the peak guard: Off, 2x, 4x, 8x or 16x. More is finer and uses more CPU.
Dither
Off, 24-bit or 16-bit. Only for the final bounce.

If it sounds wrong

If it distorts or pumps, take some Gain back, lengthen the Release (or go all the way down for Auto), or change the Style to Transparent or Safe.

Other presets to try

  • Loud Master (Mastering)
  • CD 16-bit Master (Mastering)
  • Punchy Drums (Drums)
  • Gentle Catch (Mix)

The same for every plugin: presets and A/B, Match and Delta, licence and trial, troubleshooting.