Grains Stereo Imager

A three-band stereo imager with a vectorscope and a mono check.

30 seconds to a good setting

Start from the preset Mono Bass (Bass).

Click the preset name in the header to open the list. Init gives you the factory values.

  1. Put the plugin on the track or the master and choose Mono Bass to make the lows mono, or Master Widen for a wider mix.
  2. Drag the two crossover lines sideways to decide where the low, mid and high bands begin.
  3. Drag a band up or down on the screen (or turn Low Width, Mid Width and High Width). 0% is mono, 100% is unchanged, 200% is extra wide.
  4. Watch the vectorscope: a signal that goes up is mono, a signal that goes sideways is wide.
  5. Turn on Mono Check and listen: the output is summed to mono, for checking only.
  6. Use Balance to shift the image left or right if needed, and Output for the level.

The Imager makes a signal wider or narrower. It does not turn a mono source into a stereo one.

Main controls

Low Width, Mid Width, High Width
The stereo width of each band. 0% is mono.
Low Xover and High Xover
The two split points between the bands.
Balance
Shifts the whole image left or right.
Mono Check
Listen in mono to check compatibility. For monitoring only.
Vectorscope
Up is mono, sideways is wide. A correlation below 0 means phase problems in mono.

If it sounds wrong

If the mix loses power in mono, press Mono Check, bring the widths back toward 100% or lower, and watch the correlation: below 0 is a warning.

Other presets to try

  • Master Widen (Mastering)
  • Wide Pads (Mix)
  • Focus Centre (Mix)
  • Airy Top (Mix)

The same for every plugin: presets and A/B, Match and Delta, licence and trial, troubleshooting.